Làm thế nào để bạn sửa chữa một cáp Ethernet với một clip khóa bị hỏng?

I have a 10 meter long Ethernet cable. One plug has the little locking clip missing, just like the part outlined in the red ellipse in the following picture.

If you don’t want to replace the cable or install a new jack, you have a few options:

1. Glue it into a coupler or a short extension like the ones shown below (with the coupler you will need another short run of cable on the other side):

2. Repair it with a zip tie. Use this guide for instructions: https://www.instructables.com/id/Repair-a-Broken-Ethernet-Plug/

It’s entirely possible to cut off the plug and install a new one, but you will need a crimping tool. It’s about $15. The thing is, your local store will probably charge you more than $15 for a cable – even if you buy it online, it’ll probably be close to that when you take shipping into account. Therefore, it’s cost-effective in my opinion, even if you only need it occasionally (and those pieces tend to break somewhat frequently, in my experience).

Also, if you ever need to run large amounts of cable, it’s much cheaper to buy it in bulk and cut it yourself.

Don’t forget to match the plug type to the wire type – stranded or solid (in your case, the wire is almost certainly stranded).